Disclaimer: Always refer to the official user manual of your specific device for accurate and detailed instructions. The following steps are general and may not apply exactly to the Skydroid H12.

a) Turn Off the Transmitter:

• Ensure that the transmitter is completely powered off and disconnected from any power source.

b) Remove External Components:

• If there are any external components (antennas, modules, etc.) attached to the transmitter, remove them to access the gimbal assembly.

c) Access the Internals:

• Open the transmitter casing carefully, following the guidelines in the user manual. This may involve removing screws or using special tools.

d) Disconnect Wiring:

• Identify and disconnect the wiring connecting the existing gimbal to the transmitter. Take note of the connections to ensure correct reassembly.

e) Remove the Old Gimbal:

• Once the wiring is detached, carefully remove the old gimbal from its mounting points. This might involve additional screws or fasteners.

f) Install the New Gimbal:

• Align the new gimbal with the mounting points and secure it in place using screws or other fastening mechanisms.

g) Connect Wiring for the New Gimbal:

• Reconnect the wiring for the new gimbal, ensuring a secure and proper connection.

h) Close the Casing:

• Put the transmitter casing back together, following the reverse of the disassembly process. Make sure all components are in their correct positions.

i) Calibration (if required):

• Some transmitters may require gimbal calibration after replacement. Refer to the user manual for specific calibration instructions.

Always refer to the official user manual provided by the manufacturer for accurate information and guidance tailored to your specific device. If you're unsure or uncomfortable with the process, consider seeking assistance from the manufacturer's customer support or a professional technician.